User manual AVITAL PHOENIX 2

[. . . ] Your remote is the key to your system and can be used to arm and disarm your alarm, lock and unlock your doors, "pop" your trunk, and control optional accessories such as a remote engine starter, window roll-up and garage door opener. Additional remote controls and remote control batteries can be purchased from any authorized Avital dealer, or by calling Avital Technolgies toll-free at 1-800-253-0334 (within the U. S. ) or 1-847-215-2233. 2 Phoenix2 Rev. A - Owner's Manual 0399 Electronic Scan Prevention (ESP) Your system includes ESP, which blocks electronic scanner codes preventing unauthorized operation of your system. Instant Remote Control Code Deletion In the event of a lost or stolen remote control, all remote controls can be erased from the system's memory preventing unauthorized system operation. [. . . ] Remote Panic with Safety LocksTM In a threatening situation, you can activate Remote Panic with Safety Locks. When activated, the siren will sound and the parking lights will flash. If you are inside your vehicle and the ignition key is "ON, " the doors will lock. If you are outside the vehicle with the ignition key "OFF, " the doors will unlock. To Activate 1. The siren will shut off and the parking lights will stop flashing. Interior Light Illumination When the alarm system is remotely disarmed, the vehicle interior light(s) will turn on for 30 seconds or until the ignition key is turned on. User-Programmable Passive Door Lock The system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from being locked in the vehicle. If you prefer, you can easily program the alarm to automatically lock the doors every time the alarm passively arms. (See the "Programming Table for System Features" on page 11. ) 5 Phoenix2 Rev. A - Owner's Manual 0399 User-Programmable Ignition-Controlled Door Lock/Unlock For the ultimate in security and convenience, the system is programmed to automatically lock your doors when the ignition key is turned "ON" or the engine is started, and will unlock when the ignition key is turned "OFF. " This feature can be programmed ON or OFF. (See the "Programming Table for System Features" on page 11. ) Protected Valet Mode You should place your system in Protected Valet Mode whenever your vehicle is being serviced by mechanics, car wash personnel or driven by valet parking attendants. While in the Protected Valet Mode, all alarm functions are bypassed to prevent unauthorized or accidental operation. Remote-controlled door lock/unlock , trunk release and all optional accessories will still operate. To Turn On Protected Valet Mode 1. Turn your ignition key to the "ON" position or start the engine. The LED will turn on solid red to indicate the system is in Protected Valet Mode. Turn your ignition key to the "ON" position or start the engine. The LED will turn off to indicate the system is no longer in Protected Valet Mode. Turn your ignition key to the "OFF" position Remote-Controlled Valet For your convenience, the system can be put into Valet mode via the remote control. While in Remote-Controlled Valet, all alarm functions are bypassed. To Activate Remote-Controlled Valet 1. The LED will turn on solid red to indicate the alarm is now in Remote-Controlled Valet. 6 Phoenix2 Rev. A - Owner's Manual 0399 To Deactivate Remote-Controlled Valet 1. The LED will turn off to indicate the alarm is no longer in Remote-Controlled Valet. Keyless Entry in Valet Mode While the system is in the Valet mode, you can still use your remote control to lock and unlock the doors as well as activate any optional accessory such as trunk release or remote engine starter. LED System Status Indicator The LED on your vehicle's dashboard or center console will inform you of the system status. LED Off On solid Slow flash Flashing in cycles Rapid flash Status System is disarmed In a valet mode System is armed See "Specific Zone Intrusion Identification" on page 8 Passive arming Remote-Controlled Accessory Outputs These outputs allow you to add optional remote-controlled accessories to your system such as a remote engine starter, trunk release, window roll-up, garage door opener or fuel door release. [. . . ] Repeat steps 1-7 for any other feature you wish to program. 10 Phoenix2 Rev. A - Owner's Manual 0399 Programming Table for System Features Feature Active / Passive Arming Passive Door Lock Passive Armed Confirmation Ignition-Controlled Door Lock / Unlock Door Ajar Indication Siren Duration (30 or 60 seconds) Long-Term Silent Arm / Disarm Factory Setting Passive OFF ON ON ON 30 Seconds ON No. of Chirps 4 5 6 9 12 13 14 Secondary Action Wait 3 seconds, the siren will chirp once for Active, twice Passive. Wait 3 seconds, the siren will chirp once for 60 seconds, twice for 30. [. . . ]