User manual AVITAL 6500

[. . . ] Always exercise caution and common sense when operating your AviStart system. !This product is intended for vehicles with fuel-injection and automatic transmissions only. NEVER attempt to remote start a vehicle with a manual (stick shift) transmission. NEVER attempt to remote start the engine while anyone (including pets) is in the vehicle. ! [. . . ] The LED will turn on solid red to indicate the system is in the Protected Valet Mode. Turn the ignition key to the "ON" position or start the engine. If within 45 seconds a third violation is detected, the sensor will automatically trigger the alarm. Zone #2: If a more threatening vibration or impact is detected at any time, the siren and lights will activate instantly. Remote-Controlled Sensor Bypass You can bypass the system sensor(s) at any time. The alarm system will still provide full perimeter protection. To Bypass the Sensor(s): 1. The siren will chirp twice. . . pause. . . chirp twice. . . pause. . . chirp twice. The sensor(s) is now bypassed until you remotely disarm and then re-arm your system. Previous Intrusion Alert If the vehicle had been tampered with and the alarm has been triggered, the siren will chirp 3 times upon remote disarm instead of the usual 1 chirp. Specific Zone Intrusion Identification If the alarm had been triggered in your absence, the siren will chirp 3 times upon remote disarm (Previous Intrusion Alert). When you enter the vehicle and turn the ignition "ON, " the LED will flash in cycles to specifically identify which zone triggered the alarm. LED 1 flash. . . 1 flash. . . 4 flashes. . . 4 flashes. . . Zone Impact sensor / optional sensor input Hood trigger Door trigger Trunk trigger 8 AviStart 6500 Owner's Manual - 110698 Rev. B User-Programmable Door Ajar Indication When you remotely arm the alarm system and a door is ajar (not closed), the siren will chirp 2 times, then chirp 3 times and the parking lights will flash 3 times. This feature provides audible and visual indication to prevent battery drain. (See "Programming Table for System Features" on page 15. ) NOTE: If your vehicle has factory delayed lighting, this feature will be turned OFF. User-Programmable Siren Duration Upon activation, the siren can be programmed to run for 30 or 60 seconds before it will shut off and instantly rearm. ( See the "Programming Table for System Features" on page 15. ) Alarm State Memory If your vehicle battery is disconnected and later reconnected, the system will automatically return to its last state before power was removed, whether it was armed, disarmed or in a valet mode. For example, if a mechanic disconnects the battery while the alarm is disarmed or in a valet mode, he won't trigger the alarm when he reconnects the battery. If a thief removes power while the alarm is armed, and reconnects it, the alarm will instantly sound, the parking lights will flash and the starter will be disabled. Automatic Malfunction Override In the event of a faulty sensor or alarm input trigger zone, the alarm, when remotely armed, will alert you by a series of chirps and parking light flashes. How to Interpret the Chirps and Parking Light Flashes When you press the remote control buttons, the system will respond with chirps and flashes of the parking lights to indicate the system status. An explanation of these chirp/flash acknowledgements is listed below and on the following page. Number of chirps and flashes 1 chirp, 1 flash 2 chirps, 2 flashes 2 chirps and flashes, then 3 more chirps and flashes 2 chirps and flashes, then 4 more chirps and flashes Explanation Disarming of the alarm. Armed and there is a sensor malfunction (automatically bypassed). 9 AviStart 6500 Owner's Manual - 110698 Rev. B Number of chirps and flashes 3 chirps, 3 flashes 4 chirps, 4 flashes 0 chirps, 1 flash 0 chirps, 2 flashes 2 three-second flashes or 1 three-second flash 0 chirps, 4 light flashes 0 chirps, 3 light flashes 6 chirps, 0 light flashes 2 chirps and flashes, then 3 more chirps and flashes 0 chirps, 4 light flashes Explanation Disarmed and there was an intrusion attempt. Remote start attempt and system is in Protected Valet Mode. Remote Engine Start - Safety and Counter-Theft read cover of this manual attempting to operate remote start. [. . . ] Remember to keep the ignition key and remote control in your possession. Press the remote control ARM/DISARM button for 1-2 seconds to secure your vehicle. When you return to the vehicle, press the remote control ARM/DISARM button for 1-2 seconds. Enter the vehicle (do not touch the brake pedal), turn the ignition key to the "ON" position and then press the brake pedal. [. . . ]