User manual ATLINKS VERSATIS P100

[. . . ] Electrical equipment can cause serious injury if used while you are wet or standing in water. If the base unit or charger ever falls into water, don't retrieve it until you have unplugged the power lead from the mains and the telephone line plug from the telephone socket (base unit only); then pull it out by the unplugged cables. Never use your cordless handset outdoors during a thunderstorm unplug the base unit from the telephone line and the mains socket when there are storms in your area. Interference If the sound quality gets worse as you move around while on a call, this is probably caused by interference between the handset and the base unit, perhaps because you are too near to another phone or other electrical equipment. [. . . ] NOTE: If a more recent VMWI entry is received from the same network server number of an existing VMWI entry, the new VMWI will not be stored but the date/time of the VMWI will be updated on the existing VMWI entry. After you have accessed to all new voice mail messages, VMWI will turn off automatically. When the call list is full, the new VMWI entry will replace the oldest non-VMWI entry in the call list. Delete VMWI entries To delete a single VMWI entry from the call list: 1. NOTE: If you choose DELETE ALL function in the call list, the handset will also delete all VMWI entries and CID entries. Reset Your Phone You can reset your phone to the default settings. After reset, all your personal settings will be deleted, but your phonebook, call list and redial list entries remain unchanged. Press <OK> and you are requested to enter the 4-digit system PIN. Press <OK> to re-confirm. Handset Settings Set the ringer melody for internal calls 1. Press <OK> and <UP/DOWN> to select the desired ringer melody (a total of 5 melodies for your selection) for setting ringer melody for internal calls. NOTE: The respective ringer melody will be played while browsing the melody list. Press <OK> and <UP/DOWN> to select the desired ringer melody (a total of 5 melodies for your selection) for setting ringer melody for external calls. NOTE: The respective ringer melody will be played while browsing the melody list. Press <OK> and <UP/DOWN> to select the desired ringer volume (a total of 6 ringer volume levels including VOLUME OFF). NOTE: The respective ringer volume will be played during your selection. You can also turn on the alert tones when low battery and out of range are detected. Low battery tone will be emitted while you are talking with the phone to alert you that you need to charge up your battery. Press <OK> and <UP/DOWN> to select KEY TONE / BATTERY TONE / OUT OF RANGE. Press <OK> to confirm. DEFAULT SETTINGS TROUBLESHOOTING No dialing tone when pressing <TALK ON> key 1. Check that the telephone line cord has been plugged into the base station and the phone socket. Disconnect the telephone base from the telephone jack and connect a different telephone. If there is no dial tone on that telephone either, the problem is your wiring or local service. Contact your local telephone service provider. My telephone does not ring when there is an incoming call PHONE OPERATION Make a Call Preparatory dialing Enter the phone number and press <TALK ON> to dial the number. [. . . ] Press <OK> and <UP/DOWN> to select your desired flash time (SHORT, MEDIUM, LONG). Change the system PIN code A 4-digit system PIN code is used for changing the system settings of the base station. Press <OK> and you are requested to enter the 4-digit system PIN. NOTE: If the new PIN entered in Step 6 is not matched with the new system PIN entered in Step 5, user is requested to enter the valid system PIN again in Step 5. [. . . ]