User manual ATLINKS TEMPORIS 55

[. . . ] If you don't have a jack, call your local phone company to find out how to get one installed. If so, this is normal condition as volume drops when additional phones are used at once. CAUTION: Disconnect the phone cord from the wall outlet before installing or replacing the batteries. [. . . ] Your Caller ID phone uses 3 AA-Size alkaline batteries for receiving and storing Caller ID records and for storing the numbers you use for frequently. IMPORTANT: If you are not going to use the telephone for more than 30 days, remove the batteries because they may leak and damage the unit. User may select P (PULSE) or T(TONE) dialing mode according to requirements from the local telephone company. If the telephone line cord is connected, disconnect it from the base unit. Carefully turn over the phone, use a pen or paper clip to loosen the battery cover. Open the battery compartment by pushing on the battery cover and sliding it away from the unit. If the line cord was previously connected, reattach it to the unit SIZE A A and check your memory locations. The timing of the Flash is dependent on the local telephone exchange and user may change it by setting the switch indicated at location C. Your phone should be placed on a level surface, such as a desk or table top, or you can mount it on a wall. Caller ID number received that has area code (front of the number) matches with the set area code will be filtered. Caller ID (CID) is a service available from your local telephone company. For Caller ID to work on this system, you must subscribe to Caller ID service. Your caller ID information may include the phone number, name, date and time. Enter your long distance code Reviewing Incoming Call Log Rotate the wall mounting knob as shown in the following layout: Wall mounting knob Location Rotate 180° This code will be added to the front of the telephone number by press and hold button "0". WALL MOUNTING: The knob is designed to keep this unit in place when the telephone is vertical on the wall. Install the base unit to the wall and then plug one end of line cord into the junction box and the other end into modular telephone line jack marked " ". [. . . ] The part of the phone that pops up to activate the phone line when the handset is lifted from the base. A term used to describe the phone in its active mode when the handset is off of the base cradle or when the SPEAKER button is pressed. Are you subscribed to Caller ID service from your local telephone company? [. . . ]