User manual APPLE POWER MAC G5 (2005)

[. . . ] Power Mac G5 User's Guide Includes setup, expansion, and troubleshooting information for your Power Mac G5 computer Apple Computer, Inc. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Apple. The Apple logo is a trademark of Apple Computer, Inc. , registered in the U. S. Use of the "keyboard" Apple logo (Option-Shift-K) for commercial purposes without the prior written consent of Apple may constitute trademark infringement and unfair competition in violation of federal and state laws. [. . . ] Depending upon the model of your Power Mac G5, you can install either PCI or PCI-X cards. Card type supported PCI1 PCI-X PCI-X 1 The Slot slots 2, 3, and 4 slots 2 and 3 slot 4 Card speed 64-bit, 33 MHz 64-bit, 100 MHz 64-bit, 133 MHz PCI slots can accommodate mixed-voltage (5. 0 V, 12 V, or 3. 3 V) cards, but only at 3. 3 V signaling, with 32-bit or 64-bit data widths and a 33 MHz frequency. You can add a 66 MHz card to a 33 MHz PCI slot if the card can operate at the lower 33 MHz rate. Warning: Do not use PCI cards that function only at 66 MHz in the 33 MHz PCI slots. If you have a 66 MHz PCI card, check with the card's manufacturer to see if it also works at 33 MHz. Maximum power consumption for all four expansion slots (the three PCI expansion cards and the AGP card) should not exceed 90 watts (W). 64 Chapter 3 Working Inside Your Computer To determine whether your computer has PCI or PCI-X slots, read the ID label, which is located on the side of the computer at the bottom under the air deflector. Computers with 4 DIMM slots have 33 MHz PCI slots; computers with 8 DIMM slots have 100 and 133 MHz PCI-X slots. Your computer's ID label tells you what hardware configuration you have. If you don't see "PCI-X" your computer has PCI slots. Chapter 3 Working Inside Your Computer 65 Installing Your Card You can install an AGP card in slot 1 only. Install either PCI or PCI-X cards in the slots labeled PCI 2, 3, and 4. 1 Open your computer and remove the side panel and air deflector following the directions on page 44. · Warning: To avoid damaging its internal components or the components you want to install, always turn off and then unplug your Power Mac G5. Do not attempt to install items inside it while it is plugged in. 2 Remove the screw in the port access cover, pull out the access cover, and set it aside. Note: To prevent screws from the PCI port access cover from dropping into the enclosure, you may want to use a magnetic screw driver, available at most electronic supply stores. Take care not to place the magnetic screw driver near your hard drives or media such as CDs or DVDs. Remove the screw that holds the port access cover in place. Port access cover If you need to remove the card in the AGP slot, lift up on this tab to release the catch. 3 Remove the card that you want to install from its static-proof bag and hold it by its corners, taking care not to touch the gold connector or any of the components on the card. 66 Chapter 3 Working Inside Your Computer 4 Align the card's connector with the expansion slot and press until the connector is inserted all the way into the slot. If you're installing a 12-inch card, make sure the card engages the appropriate guide. Reinstall the screw to secure the card in place. Port access opening PCI slot If the PCI card you are installing is full-length (12 inches), make sure it fits in one of these card guides. Press the card gently but firmly until the connector is fully inserted. Â Don't rock the card from side to side; instead, press the card straight into the slot. Check the connector and the slot for damage or obstructions, then try inserting the card again. If it resists and stays in place, and if its gold connectors are barely visible, the card is connected. 5 Reinsert the port access cover screw and tighten it to hold the card in place. Warning: If you remove a card from your computer and do not install a replacement, be sure to place a port access cover over the empty slot. An uncovered slot can affect the airflow that cools the computer's internal components and cause damage. 6 Replace the air deflector and side panel, following the directions that begin on page 53. Chapter 3 Working Inside Your Computer 67 Installing an AirPort Extreme Card AirPort offers an affordable and easy way to provide wireless Internet access anywhere in the home, at work, or in the classroom. 2 Position the AirPort Extreme Card with the Apple logo facing up, insert the card into the card slot, and press it firmly into the connector. The AirPort Extreme Card antenna wire is stowed underneath the sheet metal divider with a clip. Remove the wire from the clip before attaching it to the card. The AirPort Extreme Card slot is located underneath the sheet metal divider. With the Apple logo facing up, insert the AirPort Extreme Card into the card slot. Press the card firmly into the connector. Plug the antenna wire into the hole in the end of the AirPort Extreme Card. 3 Carefully connect the coaxial antenna wire to the port on the end of the AirPort Extreme Card. 68 Chapter 3 Working Inside Your Computer 4 Replace the front fan assembly, air deflector, and side panel, following the directions that begin on page 52. [. . . ] Les réparations de matériel homologué doivent être effectuées par un centre d'entretien canadien autorisé désigné par la fournisseur. La compagnie de télécommunications peut demander à l'utilisateur de débrancher un appareil suite à des réparations ou à des modifications effectuées par l'utilisateur ou en raison d'un mauvais fonctionnement. Veuillez contacter Apple pour des informations supplémentaires: Apple Canada, Inc. 7495 Birchmount Road Markham, Ontario Canada L3R 5G2 Service à la clientèle d'Apple Canada : 800-263-3394 Avertissement : Pour sa propre protection, l'utilisateur doit s'assurer que tout les fils de mise à la terre du secteur, des lignes téléphoniques et les canalisations d'eau métalliques, s'il y en a, soient raccordés ensemble. [. . . ]