User manual AMERICAN AUDIO XDM-343

[. . . ] Damages caused by manual modifications to the device or unauthorized operation by unqualified persons are not subject to warranty. For maintenance and/or service, contact an authorized American DJ® dealer. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-343 User Instructions page 1 Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust!Do not operate the mixer in extremely hot (more than 30°C / 100°F) or extremely cold (less than 5°C / 40°F) surroundings. [. . . ] Make sure that the respective PHONO / LINE / MIC switch is set to MIC. · You can connect 2 record players using the PHONO 1 jacks (18) and PHONO 2 jacks (19) on the rear panel. You can only control the record player signal after you switched the PHONO / LINE / MIC switches (5) to PHONO. If you wish to connect a third record player, switch the LINE 3 / PHONO 3 SELECTOR (29) on the rear panel to PHONO 3. You can only control the record player signal after you switched the PHONO 3-LINE 3 / LINE 4 / MIC 3 switch (5) to PHONO 3. · Connect your tape recorder, tuner, sound effects, CD player, cassette deck or any other line signals to the AMP OUTjacks (18, 19 & 20) on the rear panel. You can only control the line signals after switching the PHONO/LINE/MIC switches (5) to LINE. The signal is then controlled via the CH-1, CH-2 and CH-3 faders (6). © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-343 User Instructions page 2 Functions 10 4 3 2 1 11 5 12 13 14 6 7 8 15 16 17 9 (1) POWER SWITCH (2)MASTER LEVEL / PFL DISPLAY - The upper display shows the level of the left and right master output. The lower display shows the level of the channel currently being cued (PFL LED on). (4) BASS/MIDDLE/TREBLE CONTROL - Used to increase or decrease the LOW's, MIDs, and HIs of the input signal. (5) PHONO / LINE I MIC SWITCH - Used to select the input to be sent to the individual channel. (7) PFL/CUE BUTTONS - Use the PFL/CUE button to adjust the input level of each channel. (8) BEAT INDICATOR CHANNEL I / CHANNEL 2 - The LED lights up at every bass beat of the respective source. As soon as the LEDs blink synchronously, the speed of the two sources is synchronized. When the crossfader is set in the center position, both channels can be heard at once. (10) MIC 3 JACK - You can connect microphones with 1/4 inch (6. 3mm) jack plug or XLR-plug. (11) TALKOVER BUTTON - Press the talkover button when you want to use the microphone. When the button is pressed, all signals except the microphone level are decreased by 15dB. NOTE: The TALKOVER button only works with the microphone plugged into MIC 3 JACK. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. [. . . ] (25) AC VOLTAGE SELECTOR - Make sure that the selector is properly set. (26) GND (Ground terminal) - Connect the ground lead of the turntable with this terminal. (27) MIC I JACK - Connect your microphone with 1/4 inch (6. 3mm) jack plug here. The signals can be controlled via CHANNEL 1, if the PHONO / LINE / MIC switch (5) is set to MIC 1. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. [. . . ]