User manual AMERICAN AUDIO XDM-250T

[. . . ] Voice: (800) 322-6337 Fax: (323) 582-2610 E-mail: support@americandj. com Caution!Do not attempt any repairs yourself, doing so will void your manufactures warranty. In the unlikely event your mixer may require service, please contact American Audio® customer support. Please recycle when ever possible. XDM-250TTM Set-Up Precautions Please make any connections before you plug the mixer in. [. . . ] The headphone volume level be controlled by the Cue Level (1) control. Channel One Fader - This fader is used to control the output signal of any source assigned to its particular channel. Feather Fader PlusTM Crossfader - This fader is used to blend the output signals of channels 1 and 2 together. When the fader is in the full left position (channel 1), the output signal of channel one will be controlled by the master volume level. The same fundamentals will apply for channel two, sliding the fader from one position to another will vary the output signals of channels one and two respectively. When the crossfader is set in the center position, the output signals of both the channels 1 and channels 2 will be even. Microphone Input Jack - This jack is used to a connect a microphone to the mixer. The mic signal volume will be controlled by Mic Level volume controller (2). Headphone Jack - This jacks is used to connect a set of stereo headphones to the mixer. Always be sure the Cue Level Volume (1) is set to minimum before you put the headphones on. Hamster Switch - Changes the polarity of the Crossfader (for crabbing). Channel 1 will be activated by the right side of the crossfader (mixing from right to left), and Channel 2 will be activated by the left side of the crossfader (mixing from left to right). Channel Two Fader - This fader is used to control the output signal of any source assigned to channel two. Source Selector Switch - These switches are used to select the input source assigned to each channel. Channel 2 Bass Control - This control is used to increase (+20dB) or decrease (-30dB) the high frequency volume applied to the channel two source signal. Turn the knob counter-clockwise to decrease a value or clockwise to increase a value. Channel Two Cut Buttons - These buttons are used to cut out the Treble, Mid or Bass frequencies of the incoming audio signal. When these buttons are engaged the selected frequency level is cut by 100%. Channel 2 Treble Control - This control is used to increase (+20dB) or decrease (-30dB) the high frequency volume applied to the channel two source signal. Turn the knob counter-clockwise to decrease a value or clockwise to increase a value. Master Volume Control - This rotary knob is used to control the master output level (volume). To avoid distorted output try to maintain an average output signal level +4 dB. ©American Audio® - www. americandj. com - XDM-250TTM Instruction Manual Page 5 XDM-250TTM Controls and Features Cont. Rear Panel 19 20 21 22 23 24 25 26 24 19. [. . . ] All products covered by this warranty were manufactured after January 1, 1990, and bear identifying marks to that effect. American Audio® reserves the right to make changes in design and/or improvements upon its products without any obligation to include these changes in any products theretofore manufactured. No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with products described above. Except to the extent prohibited by applicable law, all implied warranties made by American Audio® in connection with this product, including warranties of merchantability or fitness, are limited in duration to the warranty period set forth above. [. . . ]