User manual AMERICAN AUDIO XDM-2221

[. . . ] Before the device is switched on, all fader and volume controls should be set to 0 or minimum position. Damages caused by manual modifications to the device or unauthorized operation by unqualified persons are not subject to warranty. For maintenance and/or service, contact an authorized American DJ® dealer. XDM-2221 "SKILZ" User Instructions page 3 Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust! [. . . ] · Connect your tape recorder, tuner, sound effects, CD player, and cassette decks etc. to the LEFT & RIGHT RCA LINE signals (17, 18) to the AMP OUT jacks (17, 18) on the rear panel. The signal is then controlled via the CH-1 and CH-2 faders (6) when the PHONO/AUX/LINE SWITCH on the front panel (5a, 5b) to LINE . may also be connected to the LEFT & RIGHT RCA PHONO/AUX jacks (17, 18) on the rear of the unit. You can only control this signal after you have switched the PHONO / AUX SELECTOR SWITCH (19) on the rear panel to AUX, plus you must change the PHONO/AUX/LINE SWITCH (5a, 5b) on the front panel to PHONO/AUX. The signal is then controlled via the CH-1 and CH-2 faders (6). XDM-2221 "SKILZ" User Instructions page 4 Functions (Front Panel) 4 2 3 1 13 15 10 5a 11 12 8 5b 14 6 7 9 (1) POWER SWITCH - Red LED will light when power is ON. (2) MASTER LEVEL - Dual LED's show the level of the left and right master output. (3) GAIN CONTROL - Used to set the level of the input signal for its designated channel. (4) BASS/MID/TREBLE CONTROL - Used to increase or decrease the LOW's, MID's, and HI's of the input signal. The Q-2221 features "Rotary Kills" with -30dB to +20db input control. (5a) CHANNEL 1 TRANSFORMER SWITCH (CHANGEABLE) - Used to select the input to be sent to channel 1. (7) FADER CURVE SWITCH - Changes Feather FaderTM Crossfader from a NORMAL CURVE to a QUICK CURVE (used for crabbing). (8) PFL/CUE BUTTONS - Use the PFL (Pre-Fader Levels)/CUE button to engage the input level of each channel. (9) FEATHER FADERTM CROSSFADER - Mixes the signals of channel 1 and channel 2. When the crossfader is set in the center position, both channels can be heard at once. XDM-2221 "SKILZ" User Instructions page 5 Functions [Front Panel) Cont. (10) TALKOVER BUTTON - Press the talkover button when you want to use the microphone. When the button is pressed, all signals except the microphone level are decreased by l5dB. Turn the CUE MIXING CONTROL (11) to CUE and select the desired channels with the PFL switches (8). [. . . ] (19) PHONO / AUX SELECTOR SWITCH - Changes phono to an extra line; allows the DJ to use a CD player or other input device in the same line as the phono line. When using a turntable select PHONO, and when using other input devices select AUX. The PHONO /AUX SELECTOR SWITCH gives the DJ the possibilities of 4 inputs lines (ie. [. . . ]