User manual AMERICAN AUDIO XDM-221

[. . . ] Make sure that the Power switch is set to the OFF position before connecting other devices to the mixer. If the device has been exposed to drastic temperature fluctuation (e. g. Should any liquid enter the device, disconnect from main power immediately. Have the device be checked by a qualified service technician before operating again. [. . . ] · In order to obtain the highest sound quality, only use high quality American DJ®, Ameri-CableTM cables for connecting devices. · For recording, connect your tape recorder or cassette deck to the OUTPUT REC jacks (18). · Connect your microphone to the Microphone Input (23) on the rear panel. · Connect your record player(s) to the PHONO 1 jacks (16) and the PHONO 2 jacks (17) on the rear panel. You can only control the record player signal after switching the PHONO/LINE switches (2) to phono. · Connect your tape recorder, tuner, sound effects, CD player, cassette deck or any other line signals to the AMP OUT jacks (16 & 17) on the rear panel. You can only control the line signals after switching the PHONO/LINE switches (2) to LINE. The signal is then controlled via the CH-1 and CH-2 faders (4). © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 2 Functions 12 2 3 2 1 15 13 14 7 4 8 10 6 9 11 5 (1) POWER SWITCH (2) LINE/PHONO SWITCH - Used to select the input (LINE or PHONO) to be sent to channel 1 or 2. (3) BASS/TREBLE CONTROL - Used to increase or decrease the LOW's and HIs of the input signal. (4) CHANNEL FADER CHANNEL 1 / CHANNEL 2 - Used to adjust the input level of each channel. When the crossfader is set in the center position, both channels can be heard at once. (6) BASS/TREBLE CONTROL - Used to increase or decrease the LOWs and HIs of the input signal. This means it will not be affected by the channel faders, so that you can monitor an input signal without the sound coming from the AMP output. Turn the CUE MIXING CONTROL (8) to CUE and select CH1 or CH2 with the CUE SWITCHES (9). When you turn the CUE MIXING CONTROL to PGM (CUE SWITCHES without function), you can cue the output signal of the mixer. If the CUE MIXING CONTROL is set to the center position, you can cue both the channel signal you have selected and the output signal. With the CUE LEVEL CONTROL (7), you can adjust the phones volume without changing the output signal. [. . . ] Only replace the fuse when the device is disconnected from power supply. (22) AC VOLTAGE SELECTOR - Make sure that the selector is properly set desired voltage (115V or 230V). (23) MIC INPUT - 1/4 inch (6. 3 mm) jack plug for microphone input to mixer. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-221 User Instructions page 4 Replacing the Crossfader Instructions for replacing the crossfader: · Disconnect from main power supply · Remove the fader knob. [. . . ]