User manual AEG OF 2050 E

[. . . ] Soft wood hard wood plastics aluminium Typically, the A-weighted noise levels of the tool are: Sound power level (K = 3 dB(A)). Total vibration values (vector sum in the three axes) determined according to EN 60745. 1, 5 m/s2 WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. [. . . ] Appliances used at many different locations including open air must be connected via a residual current operated device (FI, RCD, PRCD). It is recommended to wear gloves, sturdy non slipping shoes and apron. Always disconnect the plug from the socket before carrying out any work on the machine. Only use tools whose permitted speed is at least as high as the highest no-load speed of the machine. Sawdust and splinters must not be removed while the machine is running. Put the router back to original position after usage (loosen clamping lever to secure cage). Only move the workpiece in counter rotation to cutter (only work oppositely oriented)!For security, use devices such as safety- and pressure device, guide slide, rip fence, etc. The dust that arises when working with this tool can be detrimental to health (e. When working oak or bECh wood, stones, paint, which could contain lead or other harmful chemicals) and therefore not reach the body. Use a dust absorption system and wear a suitable dust protection mask. Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. SPECIFIED CONDITIONS OF USE The router can be used for rabbeting, rounding off, chamfering, routing of edges, as well as pitting in wood and plastic. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ] In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]