User manual AEG LF 650

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG LF 650. We hope that this AEG LF 650 user guide will be useful to you.


AEG LF 650 : Download the complete user guide (4832 Ko)

Manual abstract: user guide AEG LF 650

Detailed instructions for use are in the User's Guide.

[. . . ] Advice for your safety J Please pay attention to the safety instructions in the attached leaflet!It is recommended to wear gloves, sturdy non slipping shoes and apron. J Sawdust and splinters must not be removed while the machine is running. [. . . ] Swivel fence with height adjustment After unlocking the right clamping lever the height of the swivel fence can be adjusted infinitely variable. Base plate with markings for easy cutting Depth guide to pre­set three different board thicknesses Sawdust ejector, can be connected with a suction nozzle or a by­pass nozzle modifications: Text , diagrams and data are correct at the time of printing. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The size of the biscuit dowels to be used depends on the thickness of the material. Always use biscuit dowels of the biggest possible size to ensure a solid joint. If the working material is thicker than 25 mm, use 2 biscuit dowels on top of each other. Set the cutting depth with the adjustment knob according to the chosen biscuit dowel to be used. Unlock the left clamping lever, set the swivel fence with aid of the scale to the required angle (e. To be able to cut the groove for the biscuit dowel centrically, the joiner must be pre­set to the board thickness. Unlock the right clamping lever, set the swivel fence with aid of the scale to the required board thickness, and re­fasten the clamping lever. The values on the scale are only applicable when the push­on plate is fitted. Should the locked clamping lever be in the way when working with the tool, fasten it in a different position by pulling it out without unlocking it. Should the locked clamping lever be in the way when working with the tool, fasten it in a different position by pulling it out without unlocking it. Place the two boards to be joined on top of each other (flush), fix them with screw­clamps and mark the center of the grooves. Depending on the width of the boards the machine can be positioned in different ways. Wide boards: Position the machine to the workpiece such that the base plate middle marking is facing the board marking. This setting can also be used for the case that the biscuit joint is located close to the edge. Push the machine forward and plunge the Slightly release the pressure, the motor part is pulled back to the original position by resilience. [. . . ] As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D­71361 Winnenden. Accessories ENGLISH 7 The range of accessories with part numbers is shown in our catalogue. In order to correct the cutting depth, loosen the counter nut and turn the set screw as required. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG LF 650




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG LF 650 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.