User manual AEG F88060VI0P

[. . . ] The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. € Make sure that the electrical information on the rating plate agrees with the power supply. € Make sure not to cause damage to the mains plug and to the mains cable. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre. [. . . ] If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. 3 ÖKO PLUS This option decreases the temperature in the last rinse phase. Com The use of this option decreases the energy consumption (up to 25%) and the programme duration. Press the on/off button to deactivate the appliance and to confirm the setting. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time touchpads (4) and (5) until the indicators of touchpads (3), (4), (5) and (6) flash. 5 Setting the TimeBeam colour Nine colours are available for this light beam. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time touchpads (4) and (5) until the indicators of touchpads (3), (4), (5) and (6) start to flash. Each number is related to a different colour (0C = TimeBeam deactivated). Press the on/off button to deactivate the appliance and to confirm the setting. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time touchpads (4) and (5) until the indicators of touchpads (3), (4), (5) and (6) flash. Press the on/off button to deactivate the appliance and to confirm the setting. M AX + 4 3 2 - Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 1 C D You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). [. . . ] 2 How to activate the rinse aid dispenser The activation of the rinse aid dispenser can occur only with the multitab option activated. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time touchpads (4) and (5) until the indicators of touchpads (3), (4), (5) and (6) start to flash. Press the on/off button to deactivate the appliance and to confirm the setting. [. . . ]