User manual AEG-ELECTROLUX F50502ID0

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX F50502ID0. We hope that this AEG-ELECTROLUX F50502ID0 user guide will be useful to you.


AEG-ELECTROLUX F50502ID0 : Download the complete user guide (5742 Ko)

Manual abstract: user guide AEG-ELECTROLUX F50502ID0

Detailed instructions for use are in the User's Guide.

[. . . ] The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Make sure that there is access to the mains plug after the installation. €¢ Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. [. . . ] Turn the programme knob until the display shows two horizontal status bars. Press and hold, at the same time, Multitab and Delay until the indica, , and start to flash. €¢ The display shows the current setting of the water softener, e. Press the on/off button to deactivate the appliance and to confirm the setting. M AX + 4 3 2 - Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 1 C D You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. €¢ If you use the combi detergent tablets, activate the Multitab option. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. 2 Setting and starting a programme Setting mode For some settings it is necessary that the appliance is in setting mode. If the control panel does not show this condition, press and hold, at the same time, Multitab and Delay until the appliance is in setting mode. €¢ The programme starts and only the indicator of the running phase stays on. €¢ The programme duration starts to decrease with steps of 1 minute. Press Delay again and again until the display shows the delay time you want to set (from 1 to 24 hours). €¢ The countdown starts to decreases with steps of 1 hour. When the countdown is completed, the programme starts and the indicator of the running phase comes on. Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance continues from the point of interruption. [. . . ] Turn the programme knob until the display shows two horizontal status bars. Press and hold, at the same time, Multitab and Delay until the indicators , , and start to flash. €¢ The display shows the current setting of the rinse aid dispenser. Press the on/off button to deactivate the appliance and to confirm the setting. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX F50502ID0




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX F50502ID0 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.