User manual ACRONOVA XB42M4 BR CLN BROCHURE

[. . . ] The appliance must not come into contact with electrical parts once it has been installed. The consumption indications on the data plate have been calculated for this type of installation. Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. [. . . ] The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Cooling ventilation In order to cool down the external temperature of the oven, some models are fitted with a cooling fan that blows out air between the control panel and the oven door. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). When lit, the THERMOSTAT indicator light indicates that the oven is heating up to the temperature set. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob. Should the appliance be equipped with an electronic programmer, to use the electric oven, just press button ( (the symbol m will appear on the display) before selecting the desired cooking function. Never put objects directly on the oven bottom to avoid damaging the enamel coating. A temperature value can be set for all cooking modes between 60°C and Max, except for • BARBECUE (recommended: set only to MAX power level); • GRATIN (recommended: do not exceed 200°C). TRADITIONAL OVEN mode Both the top and bottom heating elements will come on. With this traditional cooking mode, it is best to use one cooking rack only: if more than one rack is used, the heat will be distributed unevenly. When the oven is turned on, the symbol m will be displayed for the entire cooking time. The cooking duration can be displayed at any time by pressing the button $ , and the time it is due to finish may be displayed by pressing the button % . Once cooking is completed, the timer will ring; to turn it off, simply press any button except the ) and * buttons. Immediate start for a specified period By programming just the duration (points 1 and 2 of the “Delayed cooking time for specified period” section), cooking will begin immediately. To cancel a cooking schedule already programmed Press the $ button, and use the ) button to set the time to: GB Button Functions: H : Timer with hours and minutes; $ : cooking time; % : end cooking time; ( : Manual change; ) : set cooking time (to count down); * : set cooking time (to start from zero) How to reset the digital clock After the appliance has been connected to the power supply, or after a power cut, the clock display will automatically reset to 0:00 and begin to blink. • Press the $ and % buttons consecutively and then reset the time (within 4 seconds) using the ) and * buttons. Press the ( button, and then use the ) and * buttons to reset the time. Manual operation of the oven Once the time has been set, the programmer automatically switches to manual mode. Note: Press the ( button to restore the manual mode after every “Automatic” cooking session. Delayed cooking time for a specified period The total cooking time as well as the time at which the cooking will finish must be set. Turn the oven control knob to the setting and temperature desired (example: static oven mode at 200°C). [. . . ] 22 Maintenance and care Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Replacing the light bulb To replace the oven light bulb: GB Cleaning the appliance • The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. If these stains are difficult to remove, use only specialised products. • Ideally, the inside of the oven should be cleaned after each use, when it is still lukewarm. [. . . ]