User manual ACER AL1913

[. . . ] 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It may include blemishes of 0. 01% or less such as a missing pixel or a pixel lit all of the time. Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image, when the same image is displayed for hours. In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours. 1 Components and Accessories LCD Display (with speakers) LCD Display (without speakers) Signal Cable Quick Start Guide Power Cable Audio Cable (with speakers) Adaptor User's Manual (CD-ROM) (Potrans: UP060B1190 or APD: DA-60F19) Usage Installation Guide Attention Note: Read the [Safety Rules] section carefully before starting the installation Before installing your LCD display, consider the following with reference to the space where the display is to be installed: To minimize the reflection of the display, protect your eyes and ensure premium quality, don't install your LCD display near windows or with backlight. The upper edge of the display should be a little higher than your sight. Adjust the front and back dip angles of the display based on your visual angle so that you can view the display comfortably. Quick Installation Complete the following steps for quick installation: (See the figure) Assemble the seat of the display Take the seat out of the box and place it on a flat table. Take your LCD display out of the carton and assemble the display and seat along the rail. You will hear a click sound when the display and seat are engaged correctly. 2 Connection to PC Make sure that the power supply of your PC is turned off and the power plug is removed. Connect and fasten both ends of the signal cable to your PC host and LCD display respectively. If your LCD display has built-in speakers, connect the audio cable attached to the display from the sound card output of your PC to the audio input on the back of your LCD display. Transformer DC end Audio Cable Signal Cable Adjustment of Display Key Definition Power Source 1 2 3 4 5 MENU > < AUTO OSD Manu Plus Minus Automatic Adjustment Power On/Off Green indication: Power is on and normal Orange indication: Sleep status in the energy-saving mode Colorless indication: Power off Press this button to enter OSD. Press this button and click < and > to adjust volume when OSD is not shown (for the model with speakers only) Press this button to exit the manual when OSD is shown. Press this button for the display to optimize the position, phase and clock pulse automatically when OSD is not shown. 6 Speaker (For the model with speakers) 3 Operation Your LCD display has been adjusted to its optimal status before shipment. Your can also adjust the image in accordance with the following illustrations and steps. Click MENU to display the OSD window as shown in the following figure. Click < or > to select the function to be adjusted as shown in the following figure. [. . . ] Remove the electronic equipment in the vicinity that may cause EMI interference. Check the signal cable of the display and ensure that no pin is bent. Image Offset or wrong Size Press the auto adjustment button to optimize the screen automatically. Set up the reference position. 6 Technical Specifications Panel Dimension Max. [. . . ]