User manual 3COM WL-537

[. . . ] OfficeConnect® Wireless 54Mbps/108Mbps 11g Cable/DSL Router User Guide 3CRWER100-75(Model:WL-537) 3CRWER200-75(Model:WL-537S) http://www. 3com. com/ 3Com Corporation 350 Campus Drive Marlborough, MA USA 01752-3064 Copyright © 2006, 3Com Corporation. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from 3Com Corporation. 3Com Corporation reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of 3Com Corporation to provide notification of such revision or change. 3Com Corporation provides this documentation without warranty, term, or condition of any kind, either implied or expressed, including, but not limited to, the implied warranties, terms or conditions of merchantability, satis34factory quality, and fitness for a particular purpose. [. . . ] 3Com recommends that you leave this feature enabled for maximum security. Enabling Remote Administration It is possible to administer the Router remotely. Select one of the following options for remote administration: Disable Remote Administration - This option is set as default. Enable administration from a single Internet Host - Only the specified Host IP Address can manage the Router. Enable administration from a whole subnet - This option allows a number of users within the specified Host Network Address and Subnet Mask to administer the Router. Enable administration from any Internet Host - This option allows any host to access the administration pages. Advanced 87 To remotely administer your Router, enter http://xxx. xxx. xxx. xxx:8000 in the location bar of the browser running on the remote computer, where xxx. xxx. xxx. xxx is the Internet IP address of the Router. Syslog Select Syslog to display the syslog screen. Check on the check box to enable this feature, and then click Save. 88 CHAPTER 5: ROUTER CONFIGURATION Status and Logs Selecting Status and Logs from the main menu displays the Status, Logs and Routing Table in yur Web browser window. The Status screen displays a tabular representation of your network and Internet connection. Status Screen Status Status and Logs 89 Logs Logs will allow you to view both the normal events, and security threats logged by the Router. Logs Screen Select Incoming Log or Outgoing Log from the Type drop-down menu. The Incoming Log will display a temporary log of the Source IP Addresses and Destination Port Numbers fo rthe incoming Internet trafic. Click the Save Log button to save this information to a file on your PC's hard drive. click the Clean button to clear all the information that is displayed. The Outgoing Log will display a temporary log of the LAN IP Addresses, Destination URLs or IP Addresses, Destination URLs or IP Address, and Service or Port Numbers for the outgoing Internet traffic. Click the Save Log button to save this information to a file on your PC's hard drive. Click the Clearn button to clear all the information that is displayed. 90 CHAPTER 5: ROUTER CONFIGURATION Routing Table Select the Routing table tab to display routing information used by the Router. The information is displayed in the form at shown as below. Support/Feedback Selecting Support/Feedback from the main menu displays the Support and Feedback screens. Support Screen Support Selecting the Support option on the main menu displays the support links screen, which contains a list of Internet links that provide information and support concerning the Router Status and Logs 91 Feedback Feedback Screen Selecting the Feedback option displays the Feedback screen and allows you to provide feedback to 3Com on the operation of your Router . This screen should not be used to obtain technical support. 92 CHAPTER 5: ROUTER CONFIGURATION 6 Basic Connection Checks TROUBLESHOOTING Check that the Router is connected to your computers and to the cable/DSL modem, and that all the equipment is powered on. Check that the LAN Status and Cable/DSL Status LEDs on the Router are illuminated, and that any corresponding LEDs on the cable/DSL modem and the NIC are also illuminated. Ensure that the computers have completed their start-up procedure and are ready for use. Some network interfaces may not be correctly initialized until the start-up procedure has completed. If the link status LED does not illuminate for a port that is connected, check that you do not have a faulty cable. [. . . ] To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing. Pour empecher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il doit etre utilize a l'interieur et devrait etre place loin des fenetres afin de Fournier un ecram de blindage maximal. Si le matriel (ou son antenne d'emission) est installe a l'exterieur, il doit faire l'objet d'une licence. INDUSTRY CANADA (IC) EMISSIONS COMPLIANCE STATEMENT AVIS DE CONFORMITÉ À LA RÉGLEMENTATION D'INDUSTRIE CANADA SAFETY COMPLIANCE NOTICE This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada. This device has been tested and certified according to the following safety standards and is intended for use only in Information Technology Equipment which has been tested to these or other equivalent standards: UL Standard 60950-1 CAN/CSA C22. 2 No. [. . . ]