User manual 3COM SSII ADV RPS Y-CABLE TYPE 2

[. . . ] Installing the Cable The SuperStack II Advanced RPS and its modules may be hot-connected to SuperStack II units. s Ensure the Power Module is correctly installed in the Chassis. Check the RPS cables are correctly engaged and locked. s Connecting Cables Before attaching the cables, check that the power demand of the product does not exceed the capacity of the Power Module you are connecting. [. . . ] For more general information and warranty details for these products, please refer to SuperStack II Advanced RPS User Guide (DUA1607-0AAA0X). This guide is written for the installation engineer and the network administrator who manages and maintains the network. Safety Information Please read the following safety information before installing the cable. ! Installation of this cable should be carried out by qualified personnel only. You must not attempt to connect the cable to any non-RPS power outlet. Damage will result to both the RPS and the SuperStack II product if you do. Full Redundancy Use the Type 2 `Y' cable to provide full redundancy (resilience) connecting one short lead to each of the two Type 2A Power Module outlets installed in the RPS chassis and the long lead to the RPS socket on the rear of the SuperStack device. After installing the cable, this guide should be stored with your other 3Com user guides. DISCLAIMER Information in this document is subject to change without notice and does not represent a commitment on the part of 3Com Technologies. 3Com Technologies reserves the right to revise or change this document without obligation of 3Com Technologies to notify any person of the revisions or changes. Information contained in this document is believed to be accurate at the time of publication but no liability whatsoever can be accepted by 3Com Technologies arising out of any use of this information. This document, or any part of it, must not be copied or reproduced on any medium without the prior consent of 3Com Technologies. In the unlikely event that this product is found to be damaged on arrival, or fails to function once installed, you should contact your distributor or reseller for advice. L'Information de Sécurité Veullez lire les instructions de sécurité suivantes avant d'installer le cable. L' installation du cable doit être faite uniquement par un personnel qualifé. ! Fault Diagnosis The LEDs on the front of the Advanced RPS Chassis provide simple at-a-glance fault diagnosis of the installed Power Modules. If you suspect a problem: s Technical Information Physical Length Weight 0. 92 metre (36 in) 1050 g (2. 3 lb) Vous ne devez en aucun cas connecter le cable à une entrée non RPS. Il en resulterait des dommages prejudiciales aux produits RPS et SuperStack II. ACKNOWLEDGEMENTS 3Com and SuperStack are registered trademarks of 3Com Corporation. [. . . ] Check the status of the LEDs on the front panel of the chassis, as described in the SuperStack II Advanced RPS User Guide, part number DUA1607-0AAA0X. s Verbinden sie das Kabel nur mit dem vorgesehenen RPS Ausgang. Bei nicht Beachtung wird der RPS und der SuperStack II beshädigt. [. . . ]